This fan is great. I now have two of this model that replaced an older model that I've had some issues with. This model seems to have addressed many of the issues I've discovered with the model it replaced.
They are fairly simple to install. Since I had a Hunter fan in place before it was much easier than a brand new install. I simply pulled off the old fan and used the old hardware that was exactly the same (albeit a different color). The shroud and baseplate were exactly the same size. I like that this model has five blades rather than 4 and I will say they are whisper quiet. I can't even hear them when they are on. I did not have to balance the blades on either fan and they move air very well. Also when they say "flush mount" they actually mean it. The shroud sits almost right next to the ceiling so it looks nice and clean. These seem to be a little more sturdy than the model it replaced.
I will say that dealing with Hunter's customer service for the old fan was...annoying. They would NOT replace the motor even though it was bad. They insisted on sending me a new switch. I had three of these fans and I changed out every part between all three fans. Guess what part was the one consistent part that didn't work? You got it...the motor. So they send me out a switch. Then when I tell them "That didn't fix the problem" well they said they had to send me a SECOND switch because the first switch might be bad as well because they sit on the shelf and can go bad so it's their policy to send a second switch. *eye twitch* Don't you people test these things before you box them up or before you send them to people? Now I'm no electrical engineer...but unless you store these things at the bottom of the ocean inside the maw of a kraken I figure they're going to work even if they sit on a shelf for three or four years. I finally just called them and said "Well the motor started making this horrible squealing noise and gets very hot if I try to turn it on." They finally had to send me THIS model as a replacement because they old model was no longer being built or sold. They then asked me to chop the wires off the old motor and mail it to them. Bully to you, Hunter Fans. Enjoy your busted motor. I also sent them back the replacement switch...because I may have had to lie to get them to send me the correct part but I am no thief. Also I don't want a switch that's been sitting inside a kraken I'm allergic to shellfish.
Good fans, semi-annoying customer service.
Manufactured on farms or in facilities that protect the rights and/or health of workers.
As certified by
Global Recycled Standard
Global Recycled Standard (GRS) certified products contain recycled content that has been independently verified at each stage of the supply chain, from the source to the final product and meet social, environmental, and chemical requirements. The purchase of Global Recycled Standard (GRS) certified products supports the use of recycled content in the supply chain. A product must contain at least 50% certified GRS material to qualify for inclusion in Climate Pledge Friendly.
Certification Body
Intertek
Certification Number
TE-00333835
